Please select the address in which work will be performed in the drop down below. Address will autofill below.
Are you elevating or altering an existing structure or constructing a new building, addition, or deck? *
If your project is not listed above, contact the Planning & Zoning department.
- Applicant
- Worksite
- Section - 1
- Section - 2
- Section - 3
- Impervious Coverage
- Attachments & Certification
If Yes, provide Application #
Worksite Details
Has this property been before the planning board in the last 5 years? *
Please attach a copy of planning board resolution.
3. Does your rear yard face a street?
Enter a proposed accessory structure below.
1. Proposed Use/Specific description of structure (What is the structure and what will it be used for/stored in it? Please be specific.)
2. Bulk Standards (Setbacks indicated on property survey)
Required
Rear Yard
1. Does your rear yard face a street?
Section 2: Accessory Structures
Accessory Structure (In-ground Pool)
2. Square footage of proposed structure
Proposed Accessory Structures
(a) Aggregate depth of front...
Aggregate depth of front and rear yards shall not be less than 30 feet and no yard shall be less than 10 feet. A minimum setback of 15 feet shall be required from the monumented borough beachfront line.
(b) Maximum permitted density...
Maximum permitted density shall be 10 dwelling units per acre.
(c) Maximum permitted density...
Maximum permitted density shall be 16 dwelling units per acre.
(d) None required if...
None required if fireproof construction.
(e) Permitted height for conforming...
Permitted height for conforming lots only. For nonconforming lots the height shall be determined only after planning Board review to assure compliance with the intent and purpose of the Zoning Law expressed in Section 35-9.4 (Schedule of area, yard and building requirements).
(f) 1. The maximum height...
1. The maximum height of a building in the R-4 Zone shall be either Option A or B as follows:
Option A - The vertical plane of the building height envelope shall not exceed seventeen and one-half (17½) feet on the north, south and west sides of the building. Fron said point, the ermitted building height envelope shall not break a thirty (30) degree slope line pitched toward the center of the building. Gable, hip and shed dormers shall be permitted on the east, west and either the north or south (but not both north and south) elevations. The total lineal footage of dormers, measured along the facis, shall not exceed fifteen (15) percent of the roof permiter.
Option B - The vertical plane of the building height envelope shall not exceed twenty one (21) feet on the north, south and west sides of the building. From said point, the permitted building height envelope shall not break a thirty (30) degree slope line pitched toward the center of the building. Gable, hip and shed dormers shall be permitted only on the east and west elevations. The total lineal footage of dormers, measured along the facia shall not exceed eight (8) percent of the roof perimeter.
2. "Building Height Envelope" is defined as the space formed by the walls of a building, using the height set forth in Option A or B, situated in compliance with the required side yard setbacks, its roof and the ground and shall not exceed the maximum height for the zone shown in Schedule I.
3. No single dormer shall exceed ten (10) feet in length measured along the facia. A dormer shall be set back a minimum of two (2) feet from the exterior vertical building wall beneath the dormer.
4. Roof overhangs not exceeding eighteen (18) inches, bay windows, chimneys, vents and roof stacks shall be exempt for the purpose of determining the building height envelope.
(g) For Accessory structures...
For accessory structures and uses, a five (5) foot setback is permitted unless more restrictive regulations are established elsewhere in this ordinance.
(h) Front yard setback...
Front yard setback distance may be reduced to the average of front yard setbacks of principal structures on all developed properties on the same side of the street within 200 feet of the property as documented by a map repared by a licensed land surveyor.
(i) The building height...
The building height and building envelope for individual dwelling units, either attached or detached shall comply with footnote (f) of this Schedule I.
(j) Chimneys, stacks, vents...
Chimneys, stacks, vents roof overhangs and gutters shall not project more than eighteen (18) inches into or over any required side yard setback line in the residential zones. Any projection over eighteen (18) inches shall be considered part of the principal structure and shall conform to all required side yard setback requirements.
Side Yard
Enter proposed driveways, walkways, patios, or fences below.
1. Bulk Standards
Rear Yard
Side Yard
Section 3: Driveways, Walkways, Patios, or Fences
Required
Certification & Fees
Total Due
Attachments
$20.00
$75.00
$75.00
$125.00
$125.00
$175.00
$125.00
$225.00
$175.00
Signature
Payment Options (NOTE: Credit Card payments include a processing fee)
• Two (2) copies of an accurate survey of property location plan to scale with proposed improvement(s)
• If property is in flood zone, submit flood zone certificate. • Impervious coverage calculation sheet for all projects involving impervious improvements
• One (1) copy of the building plan/preliminary plan for the proposed project • If survey is more than 5 years old, need affidavit from home owner for accuracy
• Site plan/plot plan for the proposed project(s)
• Copy of planning board resolution
- Shed, Sign, Hot Tub/Spa, Fence, Sidewalk, Curb, Driveway
- Swimming Pool
- Addition of less than 500 s.f to an existing residential home
- Addition of 500 s.f or more to an existing residential home
- New residential home construction
- Addition or new construction - commercial building
- Review of minor subdivision plan
- Review of major subdivision plan
- Review of site plan